Ford vehicle guide · Michigan City Ford · Michigan City, IN

Ford Explorer Battery Guide

Where is the battery in a Ford Explorer, and what should you know before replacing it? Here is what Ford's 2027 Explorer® Owner's Manual says about the 12-volt battery.

Michigan City Ford dealership building
Illustrative photo
Engine bayWhere Ford places the 12V battery
Same specWhat Ford says a replacement must match
2 minutesMinimum wait before disconnecting (non-hybrid)
Negative firstFord's disconnect order (non-hybrid)

The short answer

Ford's 2027 Explorer manual says the 12-volt battery is in the engine compartment (hybrid models also have a secondary battery behind the trim panel in the luggage compartment). Ford says to replace it with a battery of exactly the same specification. For non-hybrid models, Ford's procedure says to switch the ignition off, wait at least two minutes before disconnecting the battery, then disconnect the negative cable before the positive. After a replacement, the battery management system should be configured to match the new battery.

Where is the battery in a Ford Explorer?

ExplorerWhere Ford says the battery is
Non-hybrid modelsIn the engine compartment
Hybrid modelsPrimary battery in the engine compartment; secondary battery behind the trim panel in the luggage compartment

Ford notes that the vehicle may have more than one battery, and that removing the battery cables from only one battery does not disconnect the vehicle's electrical system.

From Ford's 2027 Explorer® Owner's Manual (edition date June 2026), pp. 370-372, read November 17, 2026.

What Ford says about replacing the battery

Ford's manual says you must replace the battery with one of exactly the same specification. The Explorer has a maintenance-free battery that does not need water added during service. Key steps from Ford's procedure for non-hybrid models:

  • Apply the parking brake and switch the ignition off.
  • Wait a minimum of two minutes before disconnecting the battery.
  • Disconnect and isolate the negative battery cable terminal.
  • Disconnect and isolate the positive battery cable terminal.

After the battery has been disconnected, Ford lists items you may need to reset, including window bounce-back, clock settings and pre-set radio stations. Ford also says to configure the vehicle's battery management system to match the replacement battery.

Battery management

Ford says not to connect an electrical device ground directly to the battery negative post, so the battery management system works correctly.

Charging it

Ford says to always use the vehicle ground point when connecting the negative cable of an external battery charger.

Acid inside

Ford warns that batteries contain sulfuric acid and should be kept out of reach of children.

Recycle the old one

Ford suggests asking your local authority about recycling old batteries.

From Ford's 2027 Explorer® Owner's Manual (edition date June 2026), pp. 369-375 and 382, read November 17, 2026. Ford's full procedure has more steps; follow your owner's manual.

Explorer low-battery messages

Ford lists these 12V battery messages for the information display:

MessageWhat Ford says
12V battery low Charge by driving Steering and brake assist limitedThe battery management system has found the 12V battery at a low state of charge
Turn power off to save batteryListed by Ford among the 12V battery messages
Electrical power saver active Some features turned off See manualListed by Ford among the 12V battery messages

Ford also says a message could appear in the information display to alert you that battery protection actions are active.

Ford also says that if the battery warning lamp illuminates while driving, it indicates a charging system error.

From Ford's 2027 Explorer® Owner's Manual (edition date June 2026), pp. 370, 374 and 375, read November 17, 2026.

Jump starting an Explorer

Ford's manual describes jump points under the hood: a positive (+) jump point under a red cover, and a negative (-) ground point on the rear mounting bolt for the cross brace. Ford's main cautions:

  • Use only a 12-volt supply to start the vehicle.
  • Do not attempt to push-start a vehicle with an automatic transmission.
  • Do not connect the negative jumper cable to any other part of the vehicle; use the ground point.
  • After starting, run both vehicles for an additional three minutes before disconnecting the jumper cables, and remove them in reverse order.
  • Do not switch the headlamps on when disconnecting the cables.

From Ford's 2027 Explorer® Owner's Manual (edition date June 2026), Jump Starting the Vehicle, pp. 330-332, read November 17, 2026.

Prefer to have it done for you? See our Ford battery service in Michigan City page.

Explorer battery service at Michigan City Ford

Our service team can test and replace your Explorer's 12-volt battery. Check our service specials for current offers.

Schedule service online. Michigan City Ford is at 3930 Franklin St. in Michigan City. Get directions.

Michigan City Ford service hours

DaysHours
Mon-Fri7:30 a.m.-5:30 p.m.
Sat8 a.m.-3 p.m.
Sunclosed

From Michigan City Ford's website, November 17, 2026. Holiday hours can differ.

Ford Explorer battery FAQ

Where is the battery on a Ford Explorer?

Ford's 2027 Explorer owner's manual says the 12-volt battery is in the engine compartment. Hybrid models also have a secondary battery behind the trim panel in the luggage compartment.

What battery does a Ford Explorer need?

Ford's 2027 Explorer manual says you must replace the battery with one of exactly the same specification, and to configure the battery management system to match the replacement battery.

Which battery cable do I disconnect first on an Explorer?

For non-hybrid models, Ford's 2027 Explorer procedure says to switch the ignition off, wait at least two minutes before disconnecting the battery, then disconnect and isolate the negative battery cable terminal before the positive.

What does 12V battery low mean on my Explorer?

Ford says the battery management system has determined that the 12V battery is at a low state of charge. The message also says to charge by driving and that steering and brake assist are limited.

Does the Explorer battery need water?

No. Ford's 2027 Explorer manual says the Explorer has a maintenance-free battery that does not require additional water during service.

Can I jump start a Ford Explorer?

Yes. Ford's 2027 Explorer manual describes positive and negative jump points under the hood and says to use only a 12-volt supply and never to push-start an automatic transmission vehicle.

Can Michigan City Ford replace my Explorer battery?

Yes. Schedule service online and our service team can test and replace your Explorer's 12-volt battery.

Sources

Battery location, replacement notes, messages and jump-start cautions are from Ford's 2027 Explorer® Owner's Manual (edition date June 2026), pp. 330-332 and 369-382, read November 17, 2026. Ford's own owner's manual for your vehicle governs; check it for the latest. Address and service hours are from Michigan City Ford's own website, checked November 17, 2026. Photo is illustrative.

  1. Ford: 2027 Ford Explorer Owner's Manual (edition date June 2026), 12V battery, jump starting and information messages, Ford Motor Company, read November 17, 2026
  2. Address and service hours (structured data), Michigan City Ford, November 17, 2026